Front Crossmember Support Plate

Front Crossmember Support Plate
REMOVAL
1. Lift up the vehicle
2. Remove the front under cover.
3. Remove the bolt and remove front crossmember support plate.
- Large type





- Small type





INSTALLATION
Install in the reverse order of removal.

NOTE: Tighten the small type crossmember support plate together with stabilizer bracket.

After installing the stabilizer bracket to the crossmember, tighten the crossmember support plate together.
Tightening torque:
Crossmember support plate: 60 N-m (6.1 kgf-m, 44.3 ft-lb)
Crossmember support plate (Tightened together with the stabilizer bracket): 25 N-m (2.5 kgf-m, 18.1 ft-lb)
Jack-up plate: 60 N-m (6.1 kgf-m, 44.3 ft-lb)