Radiator Main Fan and Fan Motor

Radiator Main Fan and Fan Motor








REMOVAL
1. Set the vehicle on a lift.
2. Remove the collector cover.
3. Disconnect the ground cable from battery.





4. Lift up the vehicle.
5. Remove the under cover.
6. Disconnect the main fan motor connector (A).





7. Remove the heat shield cover from radiator. (AT model)





8. Drain approximately 3.0 l (3.2 US qt, 2.6 Imp qt) of coolant.
9. Remove the ATF hose from the hose clip of the radiator main fan motor assembly. (AT model)





10. Lower the vehicle.
11. Remove the air intake duct.
12. Remove the reservoir tank.
13. Remove the bolts that hold the radiator main fan motor assembly and the over flow pipe.





14. Disconnect the radiator inlet hose (A) from the radiator.
15. Remove the hood stay holder (B).





16. Remove the radiator main fan motor assembly from the upper side of the vehicle.

INSTALLATION
Install in the reverse order of removal.
Tightening torque: 7.5 N-m (0.8 kgf-m, 5.5 ft-lb)








Tightening torque: 3 N-m (0.3 kgf-m, 2.2 ft-lb)





DISASSEMBLY
1. Remove the clip holding the main fan motor connector on the radiator main fan shroud.
2. Remove the nuts holding the radiator main fan to the main fan motor.





3. Remove the bolts holding the main fan motor onto the radiator main fan shroud.





ASSEMBLY
Assemble in the reverse order of disassembly.
Tightening torque: 5 N-m (0.5 kgf-m, 3.7 ft-lb)





Tightening torque: 3.4 N-m (0.3 kgf-m, 2.5 ft-lb)