Radiator Sub Fan and Fan Motor
Radiator Sub Fan and Fan MotorREMOVAL
1. Set the vehicle on a lift.
2. Remove the collector cover.
3. Disconnect the ground cable from battery.
4. Lift up the vehicle.
5. Remove the under cover.
6. Disconnect the sub fan motor connector (B).
7. Remove the heat shield cover from radiator. (AT model)
8. Drain approximately 3.0 l (3.2 US qt, 2.6 Imp qt) of coolant.
9. Lower the vehicle.
10. Remove the air intake duct.
11. Remove the bolts that hold the radiator sub fan motor assembly and the over flow pipe.
12. Disconnect the radiator inlet hose (A) from the radiator.
13. Remove the hood stay holder (B).
14. Remove the radiator sub fan motor assembly from the vehicle.
INSTALLATION
Install in the reverse order of removal.
Tightening torque: 7.5 N-m (0.8 kgf-m, 5.5 ft-lb)
Tightening torque: 3 N-m (0.3 kgf-m, 2.2 ft-lb)
DISASSEMBLY
1. Remove the clip holding the sub fan motor connector on the radiator sub fan shroud.
2. Remove the nuts holding the radiator sub fan to the sub fan motor.
3. Remove the bolts holding the sub fan motor to the radiator sub fan shroud.
ASSEMBLY
Assemble in the reverse order of disassembly.
Tightening torque: 5 N-m (0.5 kgf-m, 3.7 ft-lb)
Tightening torque: 3.4 N-m (0.3 kgf-m, 2.5 ft-lb)
