Oil Pressure Sender: Service and Repair
Oil Pressure SwitchREMOVAL
1. Remove the collector cover. (Turbo model)
2. Disconnect the ground cable from battery.
3. Remove the generator from the bracket.
4. Disconnect the terminal from oil pressure switch.
5. Remove the oil pressure switch.
INSTALLATION
1. Apply liquid gasket to the oil pressure switch threads.
Liquid gasket: THREE BOND 1324 (Part No. 004403042) or equivalent
2. Install the oil pressure switch to the cylinder block.
Tightening torque: 25 N-m (2.5 kgf-m, 18.4 ft-lb)
3. Connect the terminal to the oil pressure switch.
4. Install the generator to the bracket.
5. Connect the ground cable to battery.
6. Install the collector cover. (Turbo model)
INSPECTION
Check the oil pressure switch installation portion for oil leakage and oil seepage.