6MT

Transmission Mounting System
REMOVAL
1. PITCHING STOPPER
1. Disconnect the ground cable from the battery.
2. Remove the intercooler.
3. Remove the pitching stopper.





2. CROSSMEMBER AND CUSHION RUBBER
1. Disconnect the ground cable from the battery.
2. Lift up the vehicle.
3. Remove the center exhaust pipe.
4. Remove the rear exhaust pipe and muffler.
5. Remove the heat shield cover. (If equipped)
6. Set the transmission jack under the transmission body.

CAUTION: Always support the transmission case with a transmission jack.

7. Remove the front and rear crossmembers.





8. Remove the transmission cushion rubber.

INSTALLATION
1. PITCHING STOPPER
1. Install the pitching stopper.
Tightening torque:
T1: 50 N-m (5.1 kgf-m, 36.9 ft-lb)
T2: 58 N-m (5.9 kgf-m, 42.8 ft-lb)





2. Install the intercooler.
3. Connect the ground cable to battery.

2. CROSSMEMBER AND CUSHION RUBBER
1. Install the transmission cushion rubber.
Tightening torque: 35 N-m (3.6 kgf-m, 25.8 ft-lb)
2. Install the front crossmember and rear crossmember.
Tightening torque:
T1: 75 N-m (7.6 kgf-m, 55.3 ft-lb)
T2: 140 N-m (14.3 kgf-m, 103.3 ft-lb)





3. Remove the transmission jack.
4. Install the heat shield cover. (If equipped.
5. Install the center exhaust pipe.
6. Install the rear exhaust pipe and muffler.