Clearing Diagnostic Trouble Codes

CLEAR MEMORY MODE
1. Shift the select lever to "P" range.
2. On the [[Main Menu]] display, select the (Each System Check}.
3. On the [[System Selection Menu]] display, select the (Transmission Control System}.
4. After transmission type information pops up, select [OK].
5. On the [[Transmission Diagnosis]] display, select the (Clearing Memory}.
6. When "Done. Turn ignition switch OFF" pops up, select [OK].
7. Turn Subaru Select Monitor and ignition switch to OFF. To turn the ignition switch to ON again, wait for 10 seconds or more.

NOTE:
- To clear the previous DTC, use (Clearing Memory}. and to clear the learned value, use (Clear Memories 21.
- For detailed operation procedure, refer to the "PC application help for Subaru Select Monitor"