Rear Seat

REAR SEAT

Rear Seat (Sedan Model):

Rear Seat (Wagon Model):

REMOVAL

CAUTION:
- Airbag system satellite safing sensor is located in the lower of the rear seat cushion center. Read the cautions given in AB section before removing the rear seat.
- The airbag system is fitted with a backup power source. After disconnecting the battery ground cable, the airbag may deploy if you do not wait for 20 seconds before starting the service of airbag system.

1. SEDAN MODEL
1. Remove the two hooks while lifting up the rear seat cushion.







2. Remove the hook (A) by pushing it back while lifting the front side of the seat cushion, and remove the seat cushion.







3. Tilt the backrest forward, remove the plastic fastener at the rear mat.
4. Remove the hinge assembly center bolts.







5. Push the entire seat to the direction of arrow and remove backrest assembly LH from the hinge assembly.







NOTE: The backrest cannot be detached while the cutout on hinge assembly side and the pin on the backrest side are not aligned.

6. Similarly, remove the backrest assembly RH by performing the above step 5).
7. Remove the backrest shoulder. (Right and left)







1. Remove the bolt.
2. Moving the lower side of backrest shoulder to the direction of arrow, and remove it from the stud bolt.
3. Lift to remove the backrest shoulder.

8. Remove the two bolts at front side of the hinge assembly center.







2. WAGON MODEL
1. Remove the two hooks while lifting up the rear seat cushion.







2. Remove the hook (A) by pushing it back while lifting the front side of the seat cushion, and remove the seat cushion.







3. Remove the headrest, and then tilt the backrest forward.
4. Remove the luggage floor box.
5. Peel the plastic fastener of rear face mat and remove the hinge assembly center bolts.







6. Remove the backrest assembly LH from hinge assembly LH.







NOTE: The backrest cannot be detached while the hinge assembly side and the backrest pin are not aligned.

7. Similarly, remove the backrest assembly RH by performing the above step 8).
8. Remove the hinge assembly center bolts.







9. Remove the lower anchor bolt (A) of the outer seat belt and backrest shoulder bolt (B).







10. Remove the backrest shoulder with lifting it up.







11. Remove the belt cover (A) from the backrest shoulder, then pull the seat belt out.







INSTALLATION

Install in the reverse order of removal.

NOTE:
- After installing the backrest, make sure that each seat belt operates normally.
- Make sure that they are properly secured on each hook on the vehicle side.

Tightening torque: Refer to "COMPONENT" of "General Description".