Radiator Main Fan and Fan Motor

Radiator Main Fan and Fan Motor





REMOVAL
1. Set the vehicle on a lift.
2. Disconnect the ground cable from battery.





3. Lift up the vehicle.
4. Remove the under cover.
5. Disconnect the connector (A) of the radiator main fan motor.





6. Remove the heat shield cover. (AT model)





7. Remove the ATF hose from the clip of the radiator main fan motor assembly. (AT model)
8. Lower the vehicle.
9. Disconnect the over flow hose.
10. Remove the reservoir tank.
11. Drain approximately 2.0 l of coolant.
12. Disconnect the radiator inlet hoses from the engine.





13. Remove the bolts which hold the radiator main fan shroud to the radiator.





14. Remove the radiator main fan motor assembly.

INSTALLATION
Install in the reverse order of removal.

NOTE: If the installation of the radiator main fan motor assembly is difficult, attempt installation after loosening the bolts which hold the radiator sub fan motor assembly.

Tightening torque: 7.5 N-m (0.8 kgf-m, 5.5 ft-lb)





Tightening torque: 3 N-m (0.3 kgf-m, 2.2 ft-lb)





DISASSEMBLY
1. Remove the clip which holds motor connector onto the shroud.
2. Remove the nuts which hold the fan to the fan motor.





3. Remove the bolts which hold fan motor onto shroud.





ASSEMBLY
Assemble in the reverse order of disassembly.
Tightening torque: 5 N-m (0.5 kgf-m, 3.7 ft-lb)





Tightening torque: 3.4 N-m (0.3 kgf-m, 2.5 ft-lb)