Radiator Sub Fan and Fan Motor

Radiator Sub Fan and Fan Motor
REMOVAL
1. Set the vehicle on a lift.
2. Disconnect the ground cable from battery.





3. Lift up the vehicle.
4. Remove the under cover.
5. Remove the connector (B) of radiator sub fan motor.





6. Remove the heat shield cover. (AT model)





7. Remove the ATF hose from the clip of the radiator sub fan motor assembly. (AT model)
8. Lower the vehicle.
9. Remove the air intake duct (rear).
10. Drain approximately 2.0 l of coolant.
11. Disconnect the radiator inlet hoses from the engine.





12. Remove the bolts which hold the radiator sub fan shroud to the radiator.





13. Remove the radiator sub fan motor assembly from underneath the vehicle.

INSTALLATION
Install in the reverse order of removal.
Tightening torque: 7.5 N-m (0.8 kgf-m, 5.5 ft-lb)





Tightening torque: 3 N-m (0.3 kgf-m, 2.2 ft-lb)





DISASSEMBLY
1. Remove the clip which holds the fan motor connector to the shroud.
2. Remove the nuts which hold the fan motor.





3. Remove the bolts which hold fan motor onto shroud.





ASSEMBLY
Assemble in the reverse order of disassembly.
Tightening torque: 5 N-m (0.5 kgf-m, 3.7 ft-lb)





Tightening torque: 3.4 N-m (0.3 kgf-m, 2.5 ft-lb)