With Manufacturer's Scan Tool
Clear Memory ModeOPERATION
NOTE: When Clear Memory Mode is performed in OBD mode of Subaru Select Monitor, only DTCs are cleared.
1. SUBARU SELECT MONITOR (NORMAL MODE)
1. On the [[Main Menu]] display screen, select the {Each System Check}.
2. On the [[System Selection Menu]] display screen, select the {Engine Control System}.
3. Click the [OK] button after the information of engine type has been displayed.
4. On the [[Engine Diagnosis]] display screen, select the {Clear Memory}.
5. When the "Clear Memory?" is shown on the screen, click the [Yes] button.
6. When "Done" and "Turn ignition switch to OFF" is shown on the display screen, turn the ignition switch to OFF.
NOTE:
- Initial diagnosis of electronic throttle control is performed after memory clearance. Wait for 10 seconds or more after turning the ignition switch to ON, and then start the engine.
- For detailed operation procedure, refer to the "PC application help for Subaru Select Monitor".
2. SUBARU SELECT MONITOR (OBD MODE)
1. On the [[Main Menu]] display screen, select the {Each System Check}.
2. On the [[System Selection Menu]] display screen, select the {Engine Control System}.
3. Click the [OK] button after the information of engine type has been displayed.
4. On the [[Engine Diagnosis]] display screen, select the {OBD System}.
5. On the [[OBD Menu]] display screen, select the {Clear Diagnostic Code?}.
6. When the "Clear Diagnostic Code?" is shown on the screen, click the [Yes] button.
7. When "Done" and "Turn ignition switch to OFF" is shown on the display screen, turn the ignition switch to OFF.
NOTE:
- Initial diagnosis of electronic throttle control is performed after memory clearance. Wait for 10 seconds or more after turning the ignition switch to ON, and then start the engine.
- For detailed operation procedure, refer to the "PC application help for Subaru Select Monitor".