Air Bleeding of Control Valve
GENERAL DESCRIPTION- When ATF is drained from the automatic transmission, make sure to bleed air from the control valve after filling with the specified amount of ATF.
- Perform the procedures according to the message displayed on the Subaru Select Monitor.
PROCEDURE
1. PREPARATION FOR AIR BLEEDING
1. Cool down until the ATF temperature displayed on the Subaru Select Monitor is 60°C (140°F) or less.
2. Move the select lever to "P" range.
3. Fully apply the parking brake.
4. Lift up the vehicle.
CAUTION: While working, be sure to keep the lower edge of the tires 30 cm or more above the ground as vehicle will vibrate.
5. Connect the Subaru Select Monitor to data link connector.
6. Turn the ignition switch to ON.
7. Turn off all switches causing an electrical load, such as headlights, A/C, seat heater and rear defogger.
2. AIR BLEEDING
CAUTION: Do not turn the power of the Subaru Select Monitor OFF during work, and do not disconnect the data link connector.
1. Select (Learning and inspection mode related to AT} in the <
2. Select (AT air bleeding model in the <
3. Follow the messages displayed on the Subaru Select Monitor screen when working.
NOTE: When "AT air bleeding in progress", the "SPORT" light in the combination meter will flash at 2 Hz, and air bleed will start. When the indicator light flashing at 2 Hz turns off, the following message will appear on the screen.
4. Air bleed is complete when a message "AT air bleeding normally ended." is displayed.
NOTE:
- If a communication error occurs during air bleed, start the "AT air bleeding" over from the beginning.
- If the message "Execute AT learning again after fixing troubles of the vehicle" appears during air bleed, select [OK] and display the DTC list. After repairing the locations indicated by the DTC, start the "AT air bleeding" over from the beginning.
- If the message "AT air bleeding ended abnormally" is displayed, start the "AT air bleeding" over from the beginning.
- When communication error occurs during air bleeding, select lever does not shift occasionally. If select lever does not shift, turn the ignition switch to OFF before operating the lever.
- For detailed operation procedures, refer to the "PC application help for Subaru Select Monitor".