Extension Case Oil Seal
REPLACEMENT1. Lift up the vehicle.
2. Clean the transmission exterior.
3. Remove the drain plug (ATF.and completely drain the ATF.
CAUTION: Directly after the vehicle has been running or the engine has been long idle running, the ATF is hot. Be careful not to burn yourself.
4. Perform replacement with a new gasket, and tighten the drain plug (ATF).
Tightening torque: 25 N-m (2.5 kgf-m, 18.4 ft-lb)
5. Remove the rear exhaust pipe and muffler.
6. Remove the heat shield cover.
7. Remove the propeller shaft.
8. Using the ST, remove the oil seal.
ST 398527700 PULLER ASSY
9. Using the ST, install the oil seal.
ST 498057300 INSTALLER
10. Install the propeller shaft.
11. Install the heat shield cover.
12. Install the rear exhaust pipe and muffler.
13. Fill with ATF.
14. Bleed the air of control valve.
15. Check the level and leaks of the ATF.