Clutch Switch: Service and Repair

Clutch Switch
REMOVAL
1. Disconnect the ground cable from battery.
2. Remove the instrument panel lower cover.
3. Disconnect the connector from clutch switch.
4. Remove the clutch switches.

INSTALLATION
1. CLUTCH SWITCH (WITH CRUISE CONTROL)
1. Install so that there is a gap of 0 mm (0 in) of the clutch switch and clutch pedal stopper.
Tightening torque: 8 N-m (0.8 kgf-m, 5.9 ft-lb)





2. Measure the stroke of the clutch pedal.
Clutch pedal standard full stroke: A
5MT non-turbo model and 6MT model: 130 - 135 mm (5.12 - 5.31 in)
5MT turbo model: 135 - 140 mm (5.31 - 5.51 in)





3. If the clutch pedal stroke is out of specification, adjust the stroke.
4. Connect the clutch switch connector.

CLUTCH SWITCH (CLUTCH START)
1. Fully depress the clutch pedal and hold it.
2. Install the clutch pedal plate and clutch pedal so that the gap between them is 3.1 - 4.1 mm (0.12 - 0.16 in), and then tighten the lock nut.
Tightening torque: 8 N-m (0.8 kgf-m, 5.9 ft-lb)





3. Connect the clutch switch connector.
4. Make sure that engine does not start with clutch pedal not depressed.
5. Make sure that the engine starts with the clutch pedal fully depressed.

INSPECTION
1. Make sure that engine does not start with clutch pedal not depressed. If the engine starts, adjust the clutch switch and inspect the starter interlock circuit.
2. Make sure that the engine starts with the clutch pedal fully depressed. If the engine does not start, adjust the clutch switch and inspect the starter interlock circuit.
3. Check the clutch switch for continuity. If the resistance is not at the standard value, replace the switch.
1. Disconnect the clutch switch connector.
2. Measure the resistance between terminal 1 and 2 of the switch.





Clutch switch (Clutch start)





Clutch switch (Cruise control)





ADJUSTMENT
1. Loosen the lock nut of clutch switch (clutch start).





2. Fully depress the clutch pedal and hold it.
3. Adjust the gap of the clutch pedal plate and the clutch switch to be 3.1 - 4.1 mm (0.12 - 0.16 in).





4. Tighten the lock nut.
Tightening torque: 8 N-m (0.8 kgf-m, 5.9 ft-lb)