Oil Filter: Service and Repair
Engine Oil FilterREMOVAL
CAUTION: If the engine oil is spilt over exhaust pipe or the under cover, wipe it off with cloth to avoid emitting smoke or causing a fire.
1. Set the vehicle on a lift.
2. Lift up the vehicle.
3. Remove the under cover.
4. Drain the engine oil.
5. Remove the oil filter using ST.
ST 4985447000 OIL FILTER WRENCH
INSTALLATION
CAUTION: Do not tighten excessively, or oil may leak.
1. Clean the oil filter installation surface of the oil cooler.
2. Obtain a new oil filter and apply a thin coat of engine oil to the seal rubber.
3. Install the oil filter turning it by hand, being careful not to damage the seal rubber.
4. Tighten more (approx. 3/4 turn) after the seal rubber contacts the oil cooler. When using a torque wrench, tighten to 14 N-m (1) 4 kgf-m, 10.3 ft-lb).
5. Install the under cover.
6. Lower the vehicle.
7. Refill the engine oil.
INSPECTION
1. After installing the oil filter, run the engine and make sure that no oil is leaking around seal rubber.
NOTE: The filter element and filter case are permanently jointed; therefore, interior cleaning is not necessary.
2. Check the engine oil level.