Reading and Clearing Diagnostic Trouble Codes
Subaru Select MonitorOPERATION
1. READ DIAGNOSTIC TROUBLE CODE (DTC)
1. Prepare the Subaru Select Monitor kit.
2. Connect the diagnosis cable to Subaru Select Monitor.
3. Connect the Subaru Select Monitor to data link connector.
1. Data link connector is located in the lower portion of instrument panel (on the driver's side).
2. Connect the diagnosis cable to data link connector.
CAUTION: Do not connect scan tools other than the Subaru Select Monitor.
4. Turn the ignition switch to ON (engine OFF.and run the Subaru Select Monitor.
5. On the [[Main Menu]] display, select the (Each System Check}.
6. On the [[System Selection Menu]] display, select the (Tire pressure monitor}.
7. After (Model Year} is displayed, select [OK].
8. On the [[Tire pressure monitor diagnosis]] display, select the (Diagnostic Code(s.Display}.
NOTE:
- For detailed operation procedures, refer to the "PC application help for Subaru Select Monitor".
- For details concerning DTCs, refer to List of Diagnostic Trouble Code (DTC).
- Display all the DTCs detected.
- If a particular DTC is not properly stored in memory (due to a voltage drop of the tire air pressure monitor control module power supply, etc..when a problem occurs, a DTC suffixed with a question mark will appears on the Subaru Select Monitor display. This shows it may be an unreliable reading.
9. If communication is not possible between the tire pressure monitoring control module and the Subaru Select Monitor, check the communication circuit.
10. When DTC is not displayed, check the indicator circuit and communication circuit.
2. DATA DISPLAY
1. On the [[Main Menu]] display, select the (Each System Check}.
2. On the [[System Selection Menu]] display, select the (Tire pressure monitor}.
3. After the (Tire pressure monitor}. is displayed, select [OK].
4. On the [[Tire pressure monitor diagnosis]] display, select the (Data Display}. and then necessary data will be displayed.
- A list of the support data is shown in the following table.
1. Data monitor (Analog)
3. CLEAR MEMORY
1. On the [[Main Menu]] display, select the {2. Each System Check}.
2. On the [[System Selection Menu]] display, select the (Tire pressure monitor}.
3. After the (Tire pressure monitor}. is displayed, select [OK].
4. On the [[Tire pressure monitor diagnosis]] display, select the (Clearing Memory}.
5. When "Done" and "Turn off the ignition switch." are shown on the display screen, end the Subaru Select Monitor and turn the ignition switch to OFF.
NOTE: For detailed operation procedures, refer to the "PC application help for Subaru Select Monitor".