Battery: Service and Repair
BatteryREMOVAL
1. Disconnect tine positive (+) terminal after disconnecting the negative (-) terminal of battery.
2. Remove the harness clip of the negative terminal from the battery rod.
3. Remove the flange nut from battery rod and remove battery holder.
4. Remove the battery.
INSTALLATION
Install in the reverse order of removal.
Tightening torque: 3.5 N.m (0.4 kgf.m, 2.6 ft.lb)
NOTE:
- Clean the battery cable terminals and apply grease to retard the formation of corrosion.
- Connect the battery positive (+) terminal, and then connect the negative (-) terminal.
- After the battery is installed, initial diagnosis of the electronic throttle control is performed. Wait for 10 seconds or more after turning the ignition switch to ON, and then start the engine.