Keyless Entry Receiver: Service and Repair

Keyless Entry Control Module

REMOVAL

1. 5 DOOR MODEL
1. Disconnect the ground cable from battery.
2. Remove the left rear quarter trim.
3. Disconnect the harness connector.
4. Remove the bolt and then remove the keyless entry control module.






2. 4 DOOR MODEL
1. Disconnect the ground cable from battery.
2. Remove the rear shelf trim.
3. Disconnect the harness connector.
4. Remove the bolt and then remove the keyless entry control module.






INSTALLATION

Install in the reverse order of removal.

Tightening torque: 13 N.m (1.33 kgf.m, 9.6 ft.lb)