Trunk Lid Latch and Actuator Assembly
Trunk Lid Latch and Actuator AssemblyREMOVAL
1. Disconnect the connector to remove the trunk opener cable.
2. Remove the two bolts to remove the trunk lid latch and actuator assembly.
INSTALLATION
CAUTION: Route the safety lever wire so that it runs inside the trunk panel.
Install in the reverse order of removal.
Tightening torque: N.m (kgf.m, ft.lb)
T1: 7.5 (0.76, 5.5)
T2: 25 (2.5, 18.4)
NOTE: Apply grease to the movable part.