Radiator Sub Fan and Fan Motor

Radiator Sub Fan and Fan Motor

REMOVAL
1) Set the vehicle on a lift.
2) Disconnect the ground cable from battery.





3) Lift up the vehicle.
4) Remove the under cover.
5) Remove the connector (B) of sub fan motor assembly.





6) Remove the heat shield cover. (AT model)





7) Remove the ATF hose from the clip of the radiator sub fan shroud. (AT model)
8) Lower the vehicle.
9) Remove the air intake duct.
10) Drain approximately 2.0 l of coolant.
11) Disconnect the radiator inlet hose from engine side.





12) Remove the bolts which hold the radiator sub fan shroud onto the radiator.





13) Remove the radiator sub fan and fan motor.

INSTALLATION

CAUTION:
Confirm that the radiator hose is securely connected.

Install in the reverse order of removal.
Tightening torque:
7.5 Nm (0.8 kgf-m, 5.5 ft-lb)





Tightening torque:
3 Nm (0.3 kgf-m, 2.2 ft-lb)





DISASSEMBLY
1) Remove the clip which holds the sub fan motor assembly connector onto the radiator sub fan shroud.
2) Remove the bolts which hold the sub fan motor assembly onto the radiator sub fan shroud.





ASSEMBLY
Assemble in the reverse order of disassembly.
Tightening torque:
5 Nm (0.5 kgf-m, 3.7 ft-lb)