Installation
INSTALLATIONPITCHING STOPPER
1) Install the pitching stopper.
Tightening torque:
T1: 50 N-m (5.1 kgf-m, 36.9 ft-lb)
T2: 58 N-m (5.9 kgf-m, 42.8 ft-lb)
2) Install the air intake chamber and intake boot. (Non-turbo model)
3) Install the intercooler. (Turbo model)
4) Connect the battery ground cable to the battery.
CROSSMEMBER AND CUSHION RUBBER
1) Install the transmission cushion rubber to the transmission, and tighten the bolt (A).
2) Install the transmission cushion rubber to the center crossmember, and tighten the nut (B)
Tightening torque:
Bolt (A)
35 N-m (3.6 kgf-m, 25.8 ft-lb)
Nut (B)
35 N-m (3.6 kgf-m, 25.8 ft-lb)
3) Install the front crossmember and rear crossmember.
Tightening torque:
T1: 70 N-m (7.1 kgf-m, 51.6 ft-lb)
T2: 140 N-m (14.3 kgf-m, 103.3 ft-lb)
4) Remove the transmission jack.
5) Install the heat shield cover.
6) Install the front and center exhaust pipes. (Non-turbo model)
7) Install the center exhaust pipe. (Turbo model)
8) Install the rear exhaust pipe and muffler.
9) Lower the vehicle.
10) Connect the ground cable to battery.