Lighting - Revised Headlamp Rear Cover Screw
NUMBER: 07-65-11DATE: 05/04/11
APPLICABILITY: 2008MY and Later Tribeca
SUBJECT: Headlight Assembly Rear Cover Screw
INTRODUCTION
The purpose of this bulletin is to inform you that a new service part screw (4mm longer) is now available for the rear cover.
When replacing the headlight low beam, care must be taken to prevent over-tightening of the screw that secures the headlight assembly rear cover. If the screw is over-tightened, it could strip the headlight assembly housing, preventing the cover from being properly secured, which in turn will allow water to enter the headlight assembly. If the headlight assembly housing is stripped, the new style screw should be used.
PARTS INFORMATION
SERVICE PROCEDURE/INFORMATION
If a torque wrench is not available, tighten the new screw until the back cover edge is parallel with (equal distance from) the headlight assembly body.