Installation
INSTALLATION1) Place the disc cover between front housing and front hub unit, and tighten the four bolts.
Tightening torque:
65 N-m (6.6 kgf-m, 47.9 ft-lb)
2) Install the front drive shaft.
3) Tighten the axle nut temporarily.
4) Install the disc rotor to hub.
5) Install the disc brake caliper to the front housing.
Tightening torque:
120 N-m (12.2 kgf-m, 88.5 ft-lb)
6) While depressing the brake pedal, tighten a new axle nut to the specified torque and lock it securely.
Tightening torque:
240 N-m (24.5 kgf-m, 177 ft-lb)
CAUTION:
^ Install the wheel after installation of axle nut. Failure to follow this rule may damage the wheel bearing.
^ Be sure to tighten the axle nut to specified torque. Do not overtighten it as this may damage the wheel bearing.
7) After tightening the axle nut, lock it securely.
8) Install the front wheel and tighten the wheel nuts to specified torque.
Tightening torque:
Chromed wheel
150 N-m (15.3 kgf-m, 110.6 ft-lb)
Other than above
120 N-m (12.2 kgf-m, 88.5 ft-lb)