With Manufacturer's Scan Tool
Clear Memory ModeOPERATION
NOTE: When Clear Memory Mode is performed in OBD mode on the Subaru Select Monitor, only DTCs are cleared.
1. SUBARU SELECT MONITOR (NORMAL MODE)
1. On the [[Main Menu]], select {Each System Check}.
2. On the [[System Selection Menu]], select {Engine Control System}.
3. Select [OK] after the information of engine type has been displayed.
4. On the [[Engine Diagnosis]] display screen, select {Clearing Memory}.
5. When the "Clear Memory?" is shown on the screen, click the [Yes] button.
6. When "Done" and "Turn ignition switch to OFF" are shown on the display screen, turn the ignition switch to OFF.
NOTE:
- Initial diagnosis of electronic throttle control is performed after memory clearance. Therefore, start the engine after 10 seconds or more have passed since turning the ignition switch to ON.
- For detailed operation procedure, refer to the "PC application help for Subaru Select Monitor".
2. SUBARU SELECT MONITOR (OBD MODE)
1. On the [[Main Menu]], select {Each System Check}.
2. On the [[System Selection Menu]], select {Engine Control System}.
3. Select [OK] after the information of engine type has been displayed.
4. On the [[Engine Diagnosis]] display screen, select the {OBD System}.
5. On the [[OBD Menu]] display screen, select the {Clear Diagnostic Code}.
6. When the "Clear Diagnostic Code?" is shown on the screen, click the [Yes] button.
7. When "Done" and "Turn ignition switch to OFF" are shown on the display screen, turn the ignition switch to OFF.
NOTE:
- Initial diagnosis of electronic throttle control is performed after memory clearance. Therefore, start the engine after 10 seconds or more have passed since turning the ignition switch to ON.
- For detailed operation procedure, refer to the "PC application help for Subaru Select Monitor".