Subaru Select Monitor
Subaru Select MonitorOPERATION
1. HOW TO USE THE SUBARU SELECT MONITOR
1. Prepare the Subaru Select Monitor kit.
2. Prepare PC with Subaru Select Monitor installed.
3. Connect the SDI (Subaru Diagnostic Interface) to the PC USB port (exclusively for Subaru Select Monitor) using a USB cable.
NOTE: The dedicated port for the Subaru Select Monitor means the USB port which was used to install the Subaru Select Monitor.
4. Connect the diagnosis cable to SDI.
5. Connect the SDI to the data link connector located in the lower portion of the instrument panel (on the driver's side).
CAUTION: Do not connect any scan tools other than Subaru Select Monitor or general scan tool.
6. Start up the PC.
7. Turn the ignition switch to ON (engine OFF) and run the "PC application for Subaru Select Monitor".
8. Call up DTC and data, then record them.
NOTE: For detailed operation procedure, refer to the "PC application help for Subaru Select Monitor".
2. READ CURRENT DATA FOR ENGINE (NORMAL MODE)
1. On the [[Main Menu]], select {Each System Check}.
2. On the [[System Selection Menu]], select {Engine Control System}.
3. Click the [OK] key after the information regarding engine type has been displayed.
4. On the [[Engine Diagnosis]] display screen, select the {Current Data Display & Save}.
5. On the [[Current Data Display & Save]] display screen, select the {Normal sampling}.
6. Using the scroll key, scroll the display screen up or down until the desired data is shown.
- A list of the support data is shown in the following table.
Part 1:
Part 2:
Part 3:
3. READ CURRENT DATA FOR ENGINE (OBD MODE)
1. On the[[Main Menu]], select {Each System Check}.
2. On the [[System Selection Menu]], select {Engine Control System}.
3. Click the [OK] key after the information regarding engine type has been displayed.
4. On the [[Engine Diagnosis]] display screen, select the {OBD System}.
5. On the [[OBD Menu]] display screen, select the {Current Data Display & Save}.
6. On the [[Current Data Display & Save]] display screen, select the {All Data Display}.
7. Using the scroll key, scroll the display screen up or down until the desired data is shown.
- A list of the support data is shown in the following table.
Part 1:
Part 2:
Part 3:
4. READ FREEZE FRAME DATA FOR ENGINE (OBD MODE)
1. On the [[Main Menu]], select {Each System Check}.
2. On the [[System Selection Menu]], select {Engine Control System}.
3. Click the [OK] key after the information regarding engine type has been displayed.
4. On the [[Engine Diagnosis]] display screen, select the {OBD System}.
5. On the [[OBD Menu]] display screen, select the {Freeze Frame Data Display}.
- A list of the support data is shown in the following table.
5. V.I.N. REGISTRATION
1. On the [[Main Menu]], select {Each System Check}.
2. On the [[System Selection Menu]], select {Engine Control System}.
3. Click the [OK] key after the information regarding engine type has been displayed.
4. On the [[Engine Diagnosis]] display screen, select the {Entry VIN}.
5. Perform the procedures shown on the display screen.
NOTE: For detailed operation procedure, refer to the "PC application help for Subaru Select Monitor".