Installation

INSTALLATION

WARNING:
Always refer to "Airbag System" before performing service on the airbag modules.

1) Align the center position of the roll connector.
2) Install in the reverse order of removal.

NOTE:
Align the alignment marks on the steering wheel and steering shaft.

Tightening torque:
45 N-m (4.6 kgf-m, 33.2 ft-lb)

Column cover-to-steering wheel clearance:
2 - 4 mm (0.08 - 0.16 in)

CAUTION:
Insert the roll connector guide pin into the guide hole on the lower end of the steering wheel surface. Avoid damaging the pin.