Read Diagnostic Trouble Code (DTC)
Subaru Select MonitorOPERATION
READ DIAGNOSTIC TROUBLE CODE (DTC)
1) Prepare the Subaru Select Monitor kit.
2) Connect the diagnosis cable to the Subaru Select Monitor.
3) Connect the Subaru Select Monitor to data link connector.
(1) The data link connector is located in the lower portion of the instrument panel (on the driver's side).
(2) Connect the diagnosis cable to data link connector.
CAUTION:
Do not connect the scan tools except for Subaru Select Monitor.
4) Turn the ignition switch to ON (engine OFF) and run the Subaru Select Monitor.
5) On the [[Main Menu]], select (Each System Check).
6) On the [[System Selection Menu]], select (Tire pressure monitor).
7) Select [OK] after the (System Name) is displayed.
8) On the [[Tire pressure monitor diagnosis]], select (Diagnostic Code(s) Display).
NOTE:
^ For details concerning the operation procedure, refer to the "PC application help for Subaru Select Monitor".
^ For details concerning DTCs, refer to List of Diagnostic Trouble Code (DTC). List of Diagnostic Trouble Codes (TPM)
^ Display all the DTCs detected.
^ If a particular DTC is not properly stored in memory (due to a drop in tire pressure monitor control module power supply, etc.) when a problem occurs, the DTC which is suffixed with a question mark appears on the Subaru Select Monitor display. This shows it may be an unreliable reading.
9) If communication is not possible between the tire pressure monitoring control module and the Subaru Select Monitor, check the communication circuit.
10) When DTC is not displayed, check the indicator circuit and communication circuit.