Assembly

ASSEMBLY

1) Clean all the parts before assembly.
2) Apply NIGTIGHT LYW No. 2 grease or equivalent to each part.
3) Assemble in the reverse order of disassembly.

NOTE:
^ Refer to "COMPONENT" for each tightening torque. [1][2]Diagrams
^ When pressing in the shift position pin, insert from the left side of the vehicle.
^ Affix the harness of the shift button switch and the mode change switch at the marked positions.





^ Connect the terminals of all switches to the respective connectors.





4) After completing installation, shift the select lever from the "P" range to the "D" range, then check whether or not the selection indicator in the combination meter and the select lever position matches. Also check whether the pointer and position mark matches, and what the operating force is.