Rear Door Window Glass: Service and Repair

REAR DOOR GLASS

Rear Door Glass:

REMOVAL

1. Remove the rear door trim.
2. Remove the sealing cover.
3. Apply the protective tape (1) to the areas as shown in the figure.







4. Connect the battery ground cable and power window switch connector.
5. Operate the power window switch to move the glass to the position shown in the figure, and then remove the two bolts through service holes.







6. Remove the sash retaining bolt (A), and loosen the retaining nuts (B).







7. Move the sash (C) upward, and move the nut (B) to the position on rear door as shown in the figure.







8. Detach the rear part of door glass from sash (1), and move it backward (2). Tilt the door glass inward, and move it upward to remove (3).

CAUTION:
- Since the gear may be disengaged, do not turn regulator in the closing direction after removing glass.
- Avoid impact and damage to the glass.







9. Remove the glass run rubber.
10. Remove the door sash.

INSTALLATION

CAUTION: Make sure that the glass run rubber is placed securely in door frame and sash. Install in the reverse order of removal.