Clearing Diagnostic Trouble Codes

CLEAR MEMORY MODE

1) Place the change lever in neutral.
2) On �Main Menu> display, select {Each System Check}.
3) On �System Selection Menu� display, select {Transmission Control System}.
4) After the {Center Differential Control} is displayed, select [OK].
5) On �Transmission Diagnosis� display, select {Clearing Memory}.
6) When "Done. Turn off the ignition switch." is displayed, select [OK].
7) Turn Subaru Select Monitor and ignition switch to OFF. To turn the ignition switch to ON again, wait for 10 seconds or more.

NOTE:
^ To clear the previous DTC, use {Clearing Memory}.
^ For details concerning the operation procedure, refer to "PC application help for Subaru Select Monitor".