Operation CHARM: Car repair manuals for everyone.

Clearing Diagnostic Trouble Codes

CLEAR MEMORY MODE
1) Shift the select lever to "P" range.
2) On [Main Menu] display, select [Each System Check].
3) On [System Selection Menu] display, select [Transmission Control System].
4) After transmission type information pops up, select [OK].
5) On �Transmission Diagnosis� display, select [Clearing Memory].
6) When "Done. Turn off the ignition switch." pops up, select [OK].
7) Turn Subaru Select Monitor and ignition switch to OFF. To turn the ignition switch to ON again, wait for 10 seconds or more.

NOTE:
^ If [Clear Memory 2] is selected and performed, DTC and learned control memory are cleared. If [Clear Memory 2] is performed, perform learning control promotion.
^ For details concerning the operation procedure, refer to "PC application help for Subaru Select Monitor".