Radiator Main Fan and Fan Motor

Radiator Main Fan and Fan Motor








REMOVAL

1) Remove the collector cover.
2) Disconnect the ground cable from battery.





3) Lift up the vehicle.
4) Remove the under cover.
5) Disconnect the connector from the main fan motor.





6) Remove the heat shield cover from radiator.





7) Remove the ATF hose from the hose clip of the radiator main fan motor assembly.





8) Lower the vehicle.
9) Remove the air intake duct (Rear).
10) Remove the reservoir tank.
11) Remove the bolts which secure the radiator main fan motor assembly and the over flow pipe.





12) Remove the radiator main fan motor assembly from the upper side of the vehicle.

INSTALLATION

Install in the reverse order of removal.

CAUTION:
Check if the radiator hose and the over flow hose are properly connected.

Tightening torque:
7.5 Nm (0.8 kgf-m, 5.5 ft-lb)





Tightening torque:
3 Nm (0.3 kgf-m, 2.2 ft-lb)





DISASSEMBLY

1) Remove the clip which secures the main fan motor connector onto the radiator main fan shroud.
2) Remove the radiator main fan from the main fan motor.





3) Remove the main fan motor from the radiator main fan shroud.





ASSEMBLY

Assemble in the reverse order of disassembly.

Tightening torque:
4.41 Nm (0.45 kgf-m, 3.25 ft-lb)





Tightening torque:
3.4 Nm (0.3 kgf-m, 2.5 ft-lb)





INSPECTION

Check that the radiator main fan, radiator main fan shroud and main fan motor do not have deformation, cracks or damage.