Reading and Clearing Diagnostic Trouble Codes
Subaru Select MonitorOPERATION
1) Prepare the Subaru Select Monitor kit.
2) Connect the diagnosis cable to Subaru Select Monitor.
3) Connect the Subaru Select Monitor to data link connector.
(1) Data link connector is located in the lower portion of instrument panel (on the driver's side).
(2) Connect the diagnosis cable to data link connector.
CAUTION:
Do not connect scan tools other than the Subaru Select Monitor.
4) Turn the ignition switch to ON and run the Subaru Select Monitor.
Read Diagnostic Trouble Code (DTC)
OPERATION
1) On [[Main Menu]] display, select {Each System Check}.
2) On [[System Selection Menu]] display, select {Tire pressure monitor}.
3) After {System Name} is displayed, select [OK].
4) On [[Tire pressure monitor diagnosis]] display, select {Diagnostic Code(s) Display}.
NOTE:
^ For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".
^ For details concerning DTCs, refer to List of Diagnostic Trouble Code (DTC). Manufacturer Code Charts
^ All DTCs detected will be displayed.
^ If a particular DTC is not properly stored in memory (due to a voltage drop of the TPMS & keyless entry control module power supply, etc.) when a problem occurs, a DTC suffixed with a question mark will appears on the Subaru Select Monitor display. This shows it may be an unreliable reading.
5) If TPMS & keyless entry control module and Subaru Select Monitor cannot communicate, check the communication circuit.
6) When DTC is not displayed, check the indicator circuit and communication circuit. Tire Pressure Warning Light / Trouble Indicator Light Illumination Pattern
Clear Memory Mode
OPERATION
1) On [[Main Menu]] display, select {Each System Check}.
2) On [[System Selection Menu]] display, select {Tire pressure monitor}.
3) After the {Tire pressure monitor} is displayed, select [OK].
4) On [[Tire pressure monitor diagnosis]] display, select {Clearing Memory}.
5) When "Done" and "Turn off the ignition switch." are shown on the display screen, turn the Subaru Select Monitor and the ignition switch to OFF.
NOTE:
For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".
Read Current Data
OPERATION
1) On the [[Main Menu]], select {Each System Check}.
2) On the [[System Selection Menu]], select {Tire pressure monitor}.
3) After the {Tire pressure monitor} is displayed, select [OK].
4) On the [[Tire pressure monitor diagnosis]], select the {Data Display}, and then necessary data will be displayed.
LIST
