Front Wiper Motor and Link
FRONT WIPER MOTOR AND LINKREMOVAL
1. Disconnect the ground cable from the battery.
2. Remove the cowl panel.
3. Disconnect the connector of motor.
4. Remove the bolt, and remove the wiper link.
5. Remove the TORX(R) bolt and nuts, and remove the wiper motor assembly.
INSTALLATION
1. Connect the battery ground terminal.
2. To confirm that the motor is at the auto stop position, connect the harness to the motor and turn the wiper switch to ON/OFF once.
3. Disconnect the ground cable from battery.
4. Install the wiper motor assembly.
Tightening torque: Refer to "COMPONENT" of "General Description".
Tightening torque:
T1: 6.0 N.m (0.61 kgf.m, 4.4 ft.lb)
T2: 7.5 N.m (0.76 kgf.m, 5.5 ft.lb)
T3: 8.5 N.m (0.87 kgf.m, 6.3 ft.lb) by 115°.
T4: 22 N.m (2.24 kgf.m, 16.2 ft.lb)
5. Tighten the nut of the link plate and motor assembly.
CAUTION: Tighten the nut where rod (A) and link plate (B) is aligned in a straight line.
Tightening torque:
Tighten to 8.5 N.m (0.87 kgf.m, 6.3 ft.lb) by 115°.
6. Install each part in the reverse order of removal.
Tightening torque: Refer to "COMPONENT" of "General Description".
Tightening torque:
T1: 6.0 N.m (0.61 kgf.m, 4.4 ft.lb)
T2: 7.5 N.m (0.76 kgf.m, 5.5 ft.lb)
T3: 8.5 N.m (0.87 kgf.m, 6.3 ft.lb) by 115°.
T4: 22 N.m (2.24 kgf.m, 16.2 ft.lb)