Collision Avoidance and Parking Assist Systems: Service and Repair

REARVIEW CAMERA SYSTEM

REMOVAL

CAUTION:
- Do not drop or apply any impact to the rearview camera because it is a precision equipment.
- When removing the rearview camera, remove the screws located at the specified position only. Do not remove the screws attaching the bracket. Removing them will decrease the rearview camera attaching force.






1. Disconnect the ground cable from battery.
2. Remove the rear gate trim.
3. Remove the rear wiper motor.
4. Remove the rear gate garnish.
5. Remove the rearview camera assembly.
1. Disconnect the connector.






2. Pull out the harness, and then remove the screws.






3. Rotate the camera harness to remove the rearview camera.






INSTALLATION

CAUTION:
- If the urethane foam of connector is removed during removal, be sure to apply new urethane foam.
- Be sure to confirm the marker position, whenever the rearview camera is removed/installed/ replaced.

Install each part in the reverse order of removal.

Tightening torque:
Rear gate garnish: 4.5 N.m (0.46 kgf.m, 3.3 ftlb)
Rear wiper motor & wiper arm:

Tightening torque:
T1: 6.0 N.m (0.61 kgf.m, 4.4 ft.lb)
T2: 8.0 N.m (0.82 kgf.m, 5.9 ft.lb)