Diagram Information and Instructions

Foreword

1. ILLUSTRATION EXAMPLE
- Symbols and number of points indicate the welding method and the number of welding points. Text in brackets indicates the direction for removal of welded parts, and numbers indicate the number of plates to be drilled in panels of welded parts to be removed.
- An enclosure by a broken line indicates work from the opposite side (rear side).






2. REMOVAL DIRECTION
Division is made into the four groups of inside, outside, top, and bottom, and these directions are defined as shown in the following figure.






3. NUMBER OF PANELS TO BE DRILLED
Depending on the number of panels, drilling is done through one panel or two panels, and this number is listed together with the removal direction.

1. Drilling through one plate






2. Drilling through two plates






4. HOLE DRILLING FOR PLUG WELDING
1. Drilling of holes for plug welding in service parts






2. Drilling of holes for plug welding in service parts, matching the holes on the vehicle side.






5. MEANING OF SYMBOLS