Front Crossmember Support Plate

Front Crossmember Support Plate

REMOVAL

1) Lift up the vehicle
2) Remove the front under cover.
3) Remove the bolt and remove front crossmember support plate.
^ Large type





^ Small type





INSTALLATION

Install each part in the reverse order of removal.

NOTE:
Tighten the small type crossmember support plate together with stabilizer bracket.
After attaching the stabilizer bracket to the crossmember, tighten the crossmember support plate together with the bracket.

Tightening torque:
Crossmember support plate:
60 Nm (6.12 kgf-m, 44.3 ft-lb)
Crossmember support plate (sections tightened together with the stabilizer bracket):
25 Nm (2.55 kgf-m, 18.4 ft-lb)
Jack-up plate:
60 Nm (6.12 kgf-m, 44.3 ft-lb)