Rear Seat
DISASSEMBLY1. Remove the rear seat.
2. Remove the armrest hinge cover in the direction of the black arrow, and remove the screws to remove the armrest.
NOTE: The armrests cannot be detached while the backrest assembly RH and armrest side pin positions are not aligned.
3. Remove the backrest knob. (Screw-in type)
4. Remove the seat backrest latch cover.
5. Peel back the backrest cover and remove the hog rings.
6. Remove all the hog rings securing the backrest frame and backrest pad.
7. Remove the headrest bushing.
8. Remove the backrest pad and backrest cover from the backrest frame.
9. Disassemble the backrest assembly LH by referring to above procedures.
10. Remove the bolts on the backside of the seat cushion, and remove the seat table assembly.
11. Remove the bolts on the right and left sides, and remove the seat table assembly.
12. Remove the bolts and the seat table hinge.
13. Remove the hooks and the seat table plate..
14. Remove all the hog rings on the backside of the seat cushion, and disassemble the seat cushion cover and seat cushion pad.
15. Detach the plastic zipper and hog ring, and then remove the armrest cover.
ASSEMBLY
CAUTION:
- Do not reuse hog rings.
- Secure the hog ring using hog ring pliers.
- Install the hog rings to the specified points securely and make sure that no wrinkle or twisting on backrest cover.
Assemble each part in the reverse order of disassembly.
NOTE:
- Do not contaminate or damage the cover.
- While installing the hog rings, prevent the seat from getting wrinkled.