Front Hub Unit Bearing
Front Hub Unit BearingDISASSEMBLY
Using the ST and a hydraulic press, push out the hub bolts.
CAUTION:
^ Be careful not to hammer the hub bolts. This may deform the hub.
^ Do not reuse the hub bolt.
ST 28399AG000 HUB STAND
NOTE:
Since the hub unit bearing (1) can not be disassembled, only hub bolts can be removed.
ASSEMBLY
1) Attach the hub to the ST securely.
ST 927080000 HUB STAND
2) Using a press, press the new hub bolts until their seating surfaces contact the hub.
NOTE:
Use the 12 mm (0.47 in) dia. holes in the HUB STAND to prevent bolts from tilting.
INSPECTION
Refer to "Front Axle" for inspection procedures. Front Axle Assembly
CAUTION:
If there is any fault in the bearing, replace hub unit bearing.