Clear Memory Mode

CLEAR MEMORY MODE

OPERATION
Clear the DTC stored in the airbag control module after repairing the airbag system. (After the breakdown is recovered, the breakdown code for completed recoveries are read out when the next breakdown occurs if the memory clear work is not performed.)
1. On {{Main Menu}} display, select {Each System Check}.
2. On {{System Selection Menu}} display, select {Airbag System}.
3. Select the {Clearing Memory} in {{Airbag System }}.
4. When the "Clear Memory?" is shown on the screen, select the [OK] button.
5. When "Done" is displayed, end the Subaru Select Monitor.
6. When "Done" and "Turn Ignition Switch OFF." are shown on the display, turn the ignition switch to OFF.

NOTE:
- " For detailed operation procedures, refer to "PC application help for Subaru Select Monitor".
- Initial diagnosis of electronic throttle control is performed after memory clearance. Wait for 10 seconds or more after turning the ignition switch to ON, and then start the engine.