Curtain Airbag Sensor

CURTAIN AIRBAG SENSOR

REMOVAL

1. Turn the ignition switch to OFF.
2. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work.
3. Remove the rear seat cushion assembly and seatback shoulder.
4. Remove the nuts and then remove the curtain airbag sensor.






5. Disconnect the airbag connector.

INSTALLATION

CAUTION:
- Do not reuse the bolt and nut. Always replace with the specified new bolts and nuts.
- When installing the sensor, insert the set pin on the backside of the sensor into the hole on the body side securely.

Install each part in the reverse order of removal.

Tightening torque: 7.5 N.m (0.76 kgf.m, 5.5 ft.lb)