Front Sub Sensor

FRONT SUB SENSOR

REMOVAL

1.T urn the ignition switch to OFF.
2. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work.
3. Remove the front bumper face.
4. Remove the headlight assembly.
5. Remove the bolt, and then detach the front sub sensor.






6. Disconnect the connector from front sub sensor.

INSTALLATION
Install each part in the reverse order of removal.

CAUTION:
- Do not reuse the bolt and nut. Always replace with the specified new bolts and nuts.
- When installing the sensor, insert the set pin on the backside of the sensor into the hole on the body side securely.
- After the installation of headlight assembly, be sure to perform headlight beam adjustment.

Tightening torque: 13 N.m (1.32 kgf.m, 9.6 ft.lb)