Removal and Replacement
Select CableREMOVAL
1) Set the vehicle on a lift.
2) Shift the select lever to "N" range.
3) Disconnect the ground cable from battery.
4) Lift up the vehicle.
5) Remove the front exhaust pipe. (non-turbo model)
6) Remove the center exhaust pipe (rear). (turbo model)
7) Remove the heat shield cover.
8) Remove the snap pin and washer from the shifter arm.
9) Remove the plate assembly from the transmission case.
10) Disconnect the cable from arm COMPL.
11) Raise the claw of clamp to remove the cable from bracket.
12) Remove the select cable from plate assembly.
INSTALLATION
1) Install the select cable to plate assembly.
Tightening torque:
18 Nm (1.8 kgf-m, 13.3 ft-lb)
2) Install the select cable to the shifter arm.
3) Install the plate assembly to transmission.
Tightening torque:
T: 25 Nm (2.5 kgf-m, 18.4 ft-lb)
4) Install the washer and snap pin to the shifter arm.
5) Install new clamp paying attention to the installing direction.
6) Insert the tip of inner cable into connector hole of select lever, and fix the cable to bracket.
7) Shift the select lever to the "N" range, and then adjust the select cable position.
8) Install the heat shield cover.
9) Install the front exhaust pipe. (non-turbo model)
10) Install the center exhaust pipe (rear). (turbo model)
11) Lower the vehicle.
12) Connect the battery ground terminal.