Clearing Diagnostic Trouble Codes

Subaru Select Monitor

Clear Memory Mode

OPERATION

1) Shift the select lever to "P" range.
2) Using the Subaru Select Monitor, on the [[Main Menu]] display, select {Each System Check}.
3) On [[Each System Check Menu]] display, select {Transmission Control System}.
4) After transmission type information is displayed, select [OK].
5) On [[Transmission Diagnosis]] display, select {Clear Memory}.
6) When "Done. Turn off the ignition switch." is displayed, select [OK].
7) Turn the ignition switch to OFF. To turn the ignition switch to ON again, wait for 10 seconds or more.
8) Turn the Subaru Select Monitor to OFF.

NOTE:
^ If {Clear Memories 2} is executed, DTCs and learned control memory are cleared.
^ If {Clear Memories 2} is executed, perform learning. Programming and Relearning