Windows: Testing and Inspection
Power Window SystemINSPECTION
1. RESET OPERATION A
1. Sit in the driver's seat and close the door.
2. Turn the ignition switch to ON.
3. Operate the power window main switch to open the window glass halfway.
4. Operate the power window main switch to "UP" direction to fully close the driver's side window glass.
5. While the window glass is fully closed, hold down the power window switch to "UP" direction for one second.
6. Operate the power window main switch to "AUTO DOWN" direction to check whether the window fully opens properly. If the window does not fully open properly, repeat steps 1) to 6).
2. RESET OPERATION B
1. Sit in the driver's seat and close the door.
2. Turn the ignition switch to ON.
3. Hold down the power window main switch to "AUTO UP" (with the switch fully pulled), and turn the ignition switch to OFF immediately before the window fully closes. Keep down the power window switch until the window fully closes.
4. Hold down the power window main switch to "AUTO DOWN" (with the switch fully pushed), and turn the ignition switch to ON immediately before the window fully opens. Keep down the power window switch until the window fully opens.
CAUTION: Turn the ignition switch to OFF and then to ON within 30 seconds.
5. Perform reset operation A.
6. Check that the window operates properly by operating the "AUTO UP" and "AUTO DOWN" switch. If the window does not fully open/close properly, repeat steps 1) to 6).