Rear Wiper Motor

REAR WIPER MOTOR

REMOVAL
1. Disconnect the ground cable from the battery.
2. Remove the rear wiper arm.
3. Remove the rear gate lower trim.
4. Disconnect the harness connector of wiper motor assembly.
5. Remove the bolt, and then remove the wiper assembly.






INSTALLATION
1. Install each part in the reverse order of removal.
2. As shown in the figure, make sure that the diamond mark of the pivot cap is facing upward.






Tightening torque: Refer to "COMPONENT" of "General Description".

Tightening torque:
T1: 6.0 N.m (0.61 kgf.m, 4.4 ft.lb)
T2: 8.0 N.m (0.82 kgf.m, 5.9 ft.lb)