Trunk Lid

Trunk Lid

Trunk Lid Panel:

REMOVAL

1. TORSION BAR
1. Open the trunk lid.
2. Using the ST, remove the torsion bar from the hinge link.

CAUTION: During removal and installation, handle the torsion bar carefully, because it will generate reactive force.

Preparation tool: REMOVER (927780000)







3. Remove the torsion bars RH/LH.

2. TRUNK LID ARM
1. Disconnect the ground cable from battery.
2. Open the trunk lid to remove the trunk room trim.
3. Disconnect the trunk lid release cable.
4. Disconnect the connectors, and remove the harness clip, etc.
5. Remove the trunk lid mounting bolts, to remove the trunk lid panel from the trunk lid arm.







6. Remove the torsion bar from the trunk lid hinge link.
7. Remove the rear shelf trim.
8. Remove the bolts, then remove the trunk lid arm.







3. TRUNK LID PANEL
1. Disconnect the ground cable from battery.
2. Disconnect the connector to remove the trunk lid harness.
3. Remove the trunk lid latch and actuator assembly.
4. Remove the trunk lid garnish.
5. Remove the bolts, then remove the trunk lid panel from the trunk lid arm.







INSTALLATION

1. Install each part in the reverse order of removal.
2. Apply grease to the rotating area of hinges and the torsion bar.
3. Install while paying attention to make a uniform clearance around the trunk lid panel. For the dimension of clearance, refer to "SPECIFICATION" in "General Description".

Tightening torque: Refer to "COMPONENT" of "General Description". [Ref. to TRUNK LID PANEL, COMPONENT, General Description.]