Front Crossmember Support Plate
Front Crossmember Support PlateREMOVAL
1) Lift up the vehicle.
2) Remove the front under cover.
3) Remove the bolt, and remove the front crossmember support plate.
INSTALLATION
Install each part in the reverse order of removal.
NOTE:
Tighten the crossmember support plate together with the stabilizer bracket.
After attaching the stabilizer bracket to the crossmember, tighten the crossmember support plate together with the bracket.
Tightening torque:
Crossmember support plate:
60 Nm (6.1 kgf-m, 44.3 ft-lb)
Crossmember support plate (sections tightened together with the stabilizer bracket):
25 Nm (2.5 kgf-m, 18.4 ft-lb)
Jack-up plate:
60 Nm (6.1 kgf-m, 44.3 ft-lb)