Front Seat

Front Seat

Front Seat LH:

Front Seat RH:

REMOVAL

CAUTION: The airbag system is fitted with a backup power supply. After disconnecting the battery ground cable, the airbag may deploy if you do not wait for 60 seconds before starting the service of airbag system.

1. DRIVER'S SEAT
1. Disconnect the ground cable from battery, and wait for 60 seconds or more before starting work.
2. Remove the headrest.(Normal type seat)
3. Remove the slide rail installing bolt.
1. Tilt the backrest forward and move the seat to the front most position.
2. Remove the rear bolt cover at the rear side of the slide rail and remove the bolts.
3. Move the seat to the rearmost position, and remove the two bolts on the front side of the slide rail.

4. Disconnect the connector under the seat.
- Seat belt buckle switch connector
- Side airbag connector
- Seat heater connector (model with seat heater)

5. Remove the seat from vehicle.

2. PASSENGER'S SEAT

CAUTION: Refer to "CAUTION" of "General Description" before starting the work.

1. Disconnect the ground cable from battery, and wait for 60 seconds or more before starting work.
2. Remove the headrest.(Normal type seat)
3. Remove the slide rail installing bolt.
1. Tilt the backrest forward and move the seat to the front most position.
2. Remove the rear bolt cover at the rear side of the slide rail and remove the two bolts.
3. Move the seat to the rearmost position, and remove the two bolts on the front side of the slide rail.

4. Disconnect all the connectors of connector holder in the backside of seat cushion.
- Harness connector of occupant detection control module
- Side airbag connector
- Seat heater connector (model with seat heater)

5. Remove the seat from vehicle.

INSTALLATION
1. Install each part in the reverse order of removal.

CAUTION:
- The seat mounting bolts differ between the front mounting points and the rear mounting points. Make sure that you are using correct bolts at correct positions.
- Tighten the slide rail installing bolt gradually in several steps to the specified torque in the order as shown in the figure.

- Front (bolt A): Washer diameter 22 mm (0.87 in)
- Rear (bolt B): Washer diameter 26 mm (1.02 in)

Tightening torque:
53 N.m (5.4 kgf-m, 39.1 ft-lb)