Rear Seat

Rear Seat

Rear Seat:

REMOVAL

CAUTION:
- Airbag system satellite safing sensor is located in the lower of the rear seat cushion center. Read the cautions and warnings indicated in the AB section before removing the rear seat.
- The airbag system is fitted with a backup power supply. After disconnecting the battery ground cable, the airbag may deploy if you do not wait for 60 seconds before starting the service of airbag system.

1. Disconnect the ground cable from battery, and wait for 60 seconds or more before starting work.
2. Remove the rear seat cushion.







1. Push the corner of the seat cushion from above.
2. Push the corner of the seat cushion from above and pull the knob of the seat cushion hook towards yourself.
3. Pull the knob towards yourself and disconnect the hooks by lifting up the seat cushion.
4. Pull up the front center part of the seat cushion and disconnect the center hook.


CAUTION: If the center hook is disconnected from the vehicle body, replace the hook with the new part to prevent the decline of the fixed force of the seat.







5. Remove the hook (A) by pushing it back while lifting the front side of the seat cushion, and remove the seat cushion.







3. Remove the headrest, and then tilt the backrest forward.
4. Remove the luggage floor mat.(5 door model)
5. Turn over the mat to remove the bolt.







6. Remove the backrest from the hinge assembly LH (hinge assembly RH).







NOTE: The armrests cannot be detached while pin positions of the hinge assembly and armrest are not aligned.


INSTALLATION

CAUTION: If the hooks on the vehicle body side disengage (remained on the seat cushion side), when the rear seat cushion is removed, always replace with new hooks.







Install each part in the reverse order of removal.

Tightening torque:
Refer to COMPONENT of General Description. [Ref. to REAR SEAT, COMPONENT, General Description.]