Radiator Sub Fan
Radiator Sub Fan and Fan and MotorREMOVAL
1) Disconnect the ground cable from battery.
2) Lift up the vehicle.
3) Remove the under cover.
4) Remove the connector (B) of sub fan motor assembly.
5) Remove the heat shield cover. (AT model)
6) Remove the ATF hose from the clip of the radiator sub fan shroud. (AT model)
7) Lower the vehicle.
8) Remove the air intake duct.
9) Drain approximately 2 2 of coolant.
10) Disconnect the radiator inlet hose from engine side.
11) Remove the bolts which hold the radiator sub fan shroud onto the radiator.
12) Remove the radiator sub fan and fan motor from vehicle.
INSTALLATION
CAUTION:
Confirm that the radiator hose is securely connected.
Install in the reverse order of removal.
Tightening torque:
7.5 Nm (0.8 kgf-m, 5.5 ft-lb)
Tightening torque:
3 Nm (0.3 kgf-m, 2.2 ft-lb)
DISASSEMBLY
1) Remove the clip which holds the sub fan motor assembly connector onto the radiator sub fan shroud.
2) Remove the bolts which hold the sub fan motor assembly onto the radiator sub fan shroud.
ASSEMBLY
Assemble in the reverse order of disassembly.
Tightening torque:
5 Nm (0.5 kgf-m, 3.7 ft-lb)
INSPECTION
Check that the radiator sub fan, radiator sub fan shroud and sub fan motor assembly do not have deformation, cracks or damage.